The PairMaster gives the user the ability to verify and test basic LAN
cabling installations.  This unique LAN cable tester can identify one of
up to 16 Cable Pairs with the press of a button.   The PairMaster will
also  check  for 8 faults   including  Near   End  Crosstalk  (NEXT) for
double split pairs. 

The PairMaster LAN Cable Test Set

Click for Pix PairMaster

Features EIA / TIA 568 configuration for UTP     Ethernet and Token Ring LAN Cables Will Test Category 5 Cables Identifies 1 of 6 un-energized cable pairs     with the press of a button Tests 1/2, 3/6, 4/5, 7/8 Cable Pairs Detects 8 Faults including Near End     Cross talk (NEXT) for double split pairs 2 - seven segment LED's display Fault    Codes and Remote ID numbers Overvoltage Indication on PairMaster     and remote identifiers. Low Battery Indication Auto Power Off at end of test 4 PASS LED's (Green), 4 FAil LED's (Red) 2 Year Warranty of PairMaster One Year Warranty on Remote Identifiers

Functions
Wire Mapping
The PairMaster will check the point to point wiring ,  commonly referred
to as wire mapping.   This tells the user wether or not the cable pairs,   1/2
3/6, 4/5, 7/8 are wired correctly at both ends.  Green LED's indicates Pass
Red  LED's  indicate  Fail.   If  a  fault  is detected the corresponding Fault
Code is displayed on the large, two digit, seven segment LED's.

Near End Crosstalk (NEXT)
The NearEnd Crosstalk feature checks for excessive AC coupling between
each pair in a cable.Once again, if a fault is detected, the PairMaster will
display the Fault Code.

Cable Identification
The PairMaster can also identify a LAN cable within a bundle,by connect-
ing up to 16  available  Remote  identifiers  to  the work   station  jacks, the
PairMaster  will  identify  and display the  number of  Remote  identifiers
connected  to the  cable. The  user  can  then  easily   document the  network
topology.

Overload Protection
The PairMaster has  built   in overload  protection.  When voltage from a
Central Office Battery is detected, the unit will flash (OL) and shut down.

Remote Identifier
The  Remote Identifier is  a  small  unit used in conjuction with the Triplett
PairMaster for LAN Cable identification.  The Remote Identifier properly
terminates  the  LAN Cable when connected to  the work station wall jacks.  
It  contains   the   necessary   circuitry    to  allow  the PairMaster to verify
proper wiring  within  the  cable.  Each  of  the  16   Remote  Identifiers has
an  over-voltage  LED  which  lights  to  indicate the presence of damaging
voltage.

The PairMaster
LAN Cable Test Set Includes
2 - Remote Identifiers #1 and #2
1- RJ-45 Patch Cable ( Category 5)
2- RJ-45 Inline Couplers
1- 9V Battery
1- Instruction Manual
Cat No. 3240:  The PairMaster

The PairMaster LAN Cable Testing  Kit

Click for Pix PairMaster Kit

Includes   1-PairMaster LAN Cable Test Set 16-Remote Identifiers, #1 thru #16   1- RJ-45 Patch Cable ( Category 5)   2- RJ-45 Inline Couplers   1- 9V Battery    1- Hard-Sided Carrying Case w/strap   1- Instruction Manual

Cat No. 3241:  The PairMaster K